Table of Contents
Advertisement
Redback® A 6500 Programming Guide
5.0 CHANGING BUTTON ICONS
Changing the button Icons is simply a matter of selecting the Icon from the screen simulator and then clicking on the Icon
under the button label as highlighted in figure 5.2.
The Select Icon window should appear as shown below. From here it is possible to scroll through the icons in the icon library,
or by pressing the browse button (highlighted in figure 5.1) navigate to an icon or image stored elsewhere. Select the icon
or image and then press OK.
The updated icon should now replace the selected icon. In our case we have selected wr-Power.bmp.
We then changed the button label to "Power" by typing in the new name in the Button Label section. The new label now
appears below the icon on the wall plate simulation. (NOTE: the label can be a maximum of 12 characters long).
6.0 SAVING THE BUTTON CONFIGURATION
At the top of the programming window the location of the save file is shown (In our case the program is saved to the SD
card which is the path to the Removable disk (J:). The asterisk at the end of the path signifies that the program has
changed since it was last saved, or in our case it hasn't been saved yet.
Lets now save this by selecting File/Save (see Fig 6.1) or by pressing Ctrl+S.
8
Redback® Proudly Made In Australia
Fig 5.1
Type in new Button Label here.
Fig 5.2
BROWSE
www.altronics.com.au
Advertisement
Table of Contents
