Table of Contents
Advertisement
Redback® A 6500 Programming Guide
10.0 ADDING RELAY COMMANDS TO BUTTONS
To configure a relay command to a button, select the button from the Wall Plate Screen Simulator and then press the
"Add" button as shown in figure 9.1.
The "Add New Command" window should appear as shown in figure 9.2 and will default to the Serial command type.
Select the "Relay" tick box and the window should change to that shown below in figure 10.1.
From here we can select the relay output 1-3 (of the A 6505 Serial Hub) and determine the action for that relay. The relay
can be set to OFF or ON, the output can be set to toggle it's state each time the button is pressed or the relay can be set
to a timed output which will remain on for 10, 100, 1000 or 10,000 milliseconds (set by the "Hold" drop down box) or
any time period can be entered manually.
The Delay refers to the amount of time the system will wait after the command is exectued before performing any more
tasks. This has the option of 10,100, 1000 or 10000 milliseconds via the drop down box or any time period can be en-
tered manually.
www.altronics.com.au
Fig 10.1
Fig 10.2
Redback® Proudly Made In Australia 13
Advertisement
Table of Contents
