Basic Parameters; Lg (Changing The Language For The Help Texts); Mode (Switching Between Parameter Groups); Sens (Failure Monitoring) - WEST PAM-195-P-PVG Technical Documentation Manual

5.2

Basic parameters

5.2.1 LG (Changing the language for the help texts)

Command
LG
Either German or English can be selected for the help texts in the WPC-300 program.
CAUTION: After changing the language settings the parameter list has to be updated by pressing the
speed button "ID".

5.2.2 MODE (Switching between parameter groups)

Command
MODE
This command changes the parameter mode. Various commands (defined via STD/EXP) are blanked out in
standard mode. The several commands in expert mode have more significant influence on the system perfor-
mance. Therefore they should be changed with care.

5.2.3 SENS (Failure monitoring)

Command
SENS
This command is used to activate/deactivate the monitoring functions (4... 20 mA sensors, output current, sig-
nal range and internal failures) of the module.
ON: All monitoring functions are active. Detected failures can be reset by deactivating the ENABLE input.
This mode should be used in case of active enabling and monitoring by a PLC (READY signal).
OFF: No monitoring function is active.
AUTO: Auto reset mode. All monitoring functions are active. If the failure does not exist anymore, the mod-
ule automatically resumes to work.
Normally the monitoring functions are always active because otherwise no errors are detectable via
the READY output. Deactivating is possible especially for troubleshooting.
AUTO MODE: The module checks each second the actual failure status, which will (in case of a per-
sistent error) trigger the LED and the READY output for a short time.
Page 17 of 27
Parameters
X x= DE|EN
Parameters
X x= STD|EXP
Parameters
X x= ON|OFF|AUTO
PAM-195-P-PVG
Unit
-
Unit
-
Unit
-
Group
STD
Group
STD
Group
STD
18.06.2019