Table of Contents
Advertisement
Recording audio
Make sure that all your components are
correctly connected before recording audio.
Recording audio on MD, tape, or
hard disk
You can use the receiver to record audio on mini
disks (MD), tapes, or to your hard disk with the
appropriate software. For details about how to
perform this procedure, refer to the
documentation of your MD player, tape player,
or audio recorder.
1
Press INPUT SELECTOR to select a
connected component (programme
source).
2
Prepare the selected component for
recording.
For example, insert a VCD into your VCD
player.
3
Insert an MD or tape into the audio
recording device, and adjust the
recording level.
4
Start recording on the audio recording
device, and then start playback.
Notes
• Audio adjustment does not affect the signal output
from the HDD/MD OUT jack of the receiver.
• You cannot record signals using copy-protection
technology.
• You cannot output audio input to a digital input jack
to an analogue output jack. Connect to an analogue
input jack.
• You cannot record audio played back with Network
Media.
GB
48
Using the Sleep Timer
You can set the receiver to turn off automatically
at a specific time by using the remote.
1
Press the black MAIN MENU button
repeatedly until SET UP appears on
the display.
2
Press
/
to select OFF.
3
Press
/
to select the time.
The display changes cyclically as follows:
OFF (sleep mode disabled) t 2:00:00
(shutdown in two hours) t 1:30:00
(shutdown in one and a half hour) t
1:00:00 (shutdown in one hour) t 0:30:00
(shutdown in half an hour)
When using the Sleep Timer, SLEEP
appears on the display.
Tip
To check the remaining time before the receiver turns
off, perform steps 1 and 2 above. The remaining time
appears on the display.
Advertisement
Table of Contents
