Setting Water Hardness Level; Setting Rinse Aid Level - Lamona LAM8303 User Instructions

Setting water hardness level / adding dishwasher salt
Setting the correct water hardness programme by adding dishwasher salt to
increase washing efficiency and performance.
Switch On
Press and hold
(display counts
down 3,2,1)
Press and
hold until
display shows
Select water
hardness setting
(r...)
Press to select
new water
hardness setting
Switch Off
to save new water
hardness setting
Setting rinse aid level / adding rinse aid
Rinse aid helps dry the dishes without streaks and stains. It is automatically
released during the hot rinse phase.
Switch On
Press and hold
(display counts
down 3,2,1)
Press and
hold until
display shows
Select rinse
aid setting
(P...)
Press to select new
rinse aid setting
Switch Off
to save new
rinse aid setting
www.howdens.com
Cancel
3 sec.
Cancel
3 sec.
Cancel
3 sec.
Cancel
3 sec.
Cancel
3 sec.
Cancel
3 sec.
Cancel
3 sec.
Cancel
3 sec.
Cancel
3 sec.
Cancel
3 sec.
Cancel
3 sec.
Cancel
3 sec.
To add the salt, pour one litre of cold water into the salt
container and then completely fill with dishwasher salt.
Load
Some water and salt may spill out of the container. It is
recommended to use a rinse programme or complete
a wash cycle to remove any spilled salt and prevent
Load
possible corrosion.
Load
Load
Load
Load
If there are stains on tableware items after washing
the level must be increased and if there is a blue trace
Load
after wiping them by hand, it must be decreased.
Adjust the setting from the values 0,1,2,3,4 (factory
pre-set, level 3).
Load
Load
2
Load
Load
Load
1
7