Infortrend EonStor DS S12 Series Hardware Manual page 91

EonStor DS S12/S16/S24 Series Hardware Manual
For JBODs S12S-J1000G and S16S-J1000R/S
RAID Models
S12E-G1140
S12F-G1440 S12S-J1000-G
S12F-G1842
S16E-G1140
S16F-G1440
S16F-G1840 S16S-J1000-S
S24F-G1440
S24F-G1840
S16F-R1440
S16F-R1840
S16S-J1000-R
S24F-R1440
S24F-R1840
There is a rotary ID switch on every expansion enclosure that is manually configured
using a flat blade screwdriver.
Configuring enclosure IDs:
 The configurable IDs for JBODs are from 1 to 6. Usually the numbering starts
from the one closest to the managing RAID enclosure.
 The S12/S16/S24 RAID subsystems described in this manual connect to a
maximum of 6 JBODs.
 Make sure a unique ID is configured on each JBOD so that the SAS WWN
addresses of disk drives can be properly assigned. RAID system firmware
automatically manages these addresses.
JBOD
Single-controller; single path
Single-controller; single path
Dual-controller; fault-tolerant paths
91
Configuration