Timer-Recording Radio Programmes - Sony MHC-NX3AV Operating Instructions (primary manual) Operating Instructions Manual

Timer-recording radio
programmes
To timer-record, you must preset the radio
station (see "Step 4: Presetting radio
stations") and set the clock (see "Step 3:
Setting the time") beforehand.
3,4
2
TIMER SELECT
1
Tune in the preset radio station (see
"Listening to the radio" on page 14).
2
Press CLOCK/TIMER.
"SET (DAILY 1)" appears.
3
Press V or v to select "REC", then
press ENTER.
"ON" appears and the hour digits flash
in the display.
7
·
ª ·
ª ·
= + p
0 ) P
V
3,4
B b
v
·
p
REC
4
Set the time to start recording.
Press V or v to set the hour, then press
ENTER.
The minute indication starts flashing.
Press V or v to set the minute, then press
ENTER.
The hour indication flashes again.
5
Set the time to stop recording
following the above procedure.
The start time appears, followed by the
stop time, the recording source and the
radio station, then the original display
appears.
6
Insert a recordable tape into deck B.
7
Turn off the power.
When the recording starts, the volume
level is set to the minimum.
To check the setting
Press TIMER SELECT and press V or v to
select "REC", then press ENTER. To change
the setting, start over from step 1.
To cancel the timer operation
Press TIMER SELECT and press V or v to
select "TIMER OFF", then press ENTER.
Note
If the power is on at the preset time, the recording
will not be made.
REC
37