Summary of Contents for Salvis Fresh & Smart 1100
- Page 1 Salvis Fresh & Smart 1100 Operating instructions SALVIS AG CH-4665 Oftringen www.salvis.ch...
- Page 2 Salvis Fresh & Smart 1100 The Salvis Fresh & Smart 1100 conforms to the directives 89/336 and 73/23/EWG, low voltage. The respective documentation is located at the manufacturer’s site. We reserve the right to make technical changes! Due to continuous development, the figures, functional steps and specifications can vary slightly.
-
Page 3: Table Of Contents
Salvis Fresh & Smart 1100 Table of Contents General ..........................4 Initial Notes .......................... 4 Symbols for user notes ......................4 Laws, standards and guidelines ..................4 Scope of delivery ......................... 5 Notes for the operator......................5 Guarantee ..........................5 Safety .......................... -
Page 4: General
Salvis Fresh & Smart 1100 General Initial Notes The operating instructions were compiled specifically for the operating personnel of the Salvis Fresh & Smart 1100. They contain important instructions for the assembly, setup, operation and cleaning of the system. Please read the operating instructions thoroughly prior to the initial start-up and make sure that all operators read these instructions prior to using this system. -
Page 5: Scope Of Delivery
• Guarantee Basically, the “General business terms“ of Salvis AG, Nordstrasse 15, 4665 Oftringen, Switzerland, apply, which include details regarding warranty issues. Warranty claims can only be made if the appliance has been used properly and for its intended purpose (see next chapter “Safety“). -
Page 6: Safety
Safety Proper use The Salvis Fresh & Smart 1100 is an exhaust system that – in combination with adequate and similar-sized Salvis Smartline cooking appliances – removes cooking odors and expelled moisture. Please observe the respective operating instructions of the set cooking appliances for proper use. -
Page 7: Product Description
Salvis Fresh & Smart 1100 Product description The Salvis Fresh & Smart is an exhaust system that – in combination with adequate and similar-sized Salvis Smartline cooking appliances – removes cooking odours and expelled moisture at any location. Please observe the respective operating instructions of the set cooking appliances for proper use. -
Page 8: Transport / Setup / Assembly
Salvis Fresh & Smart 1100 Transport / Setup / Assembly During the setup and installation phase, the applicable electro-technical regulations as well as the directives regarding fire protection and the local construction police rules must be observed. The appliance must be installed, operated and serviced properly according to this manual to warrant its flawless operation and operational safety. -
Page 9: Operation
Salvis Fresh & Smart 1100 Operation General notes on safety Attention! Rollover and tipover danger! When transporting the Fresh & Smart across uneven terrain, you can lose control of it. Do not release or let the module roll alone during transport. -
Page 10: Starting Up The Smartline Cooking Appliance Components
Let the set cooking appliances cool off completely before you begin cleaning and removing the cooking appliances and the Fresh & Smart. If you would like to move the Salvis Fresh & Smart to a different location, please remove the set cooking appliances or prevent them from moving. -
Page 11: Cleaning And Care
Salvis Fresh & Smart 1100 Cleaning and care General For systems and appliances, in which food is prepared or offered, cleaning is of a high priority. Therefore, the operating personnel must follow the instructions in Chapter “Cleaning and Care” to maintain the proper hygienic conditions. - Page 12 Salvis Fresh & Smart 1100 Cleaning the filter area Make sure that the Salvis Fresh & Smart is separated from the mains supply. To clean the filter area, open the revision panel with a wide slot screwdriver by turning the locking knobs a fourth of a turn counter-clockwise.
-
Page 13: Regular Cleaning And Care Of The Smartline Cooking Appliance Components
Salvis Fresh & Smart 1100 Activated carbon molecular filters The active carbon molecular filters are inserted into the bottom and serve as odour eliminator. Their effectiveness depend on the type of expelled moisture and their grease content. In order to achieve a constant optimised odour binding, we recommend to replace the activated carbon molecular filters after approximately 500 operating hours. -
Page 14: End Of Operation And Breaks During Operation
Prior to taking the Fresh & Smart out of service for an extended period of time, please remove the connection cables from the receptacle. All power-related functional elements will no longer receive electrical power. The Salvis Fresh & Smart is turned off. Attention! Switch off all set cooking function elements after each use of the appliance independent of the Fresh &... -
Page 15: Errors And Possible Causes
Salvis Fresh & Smart 1100 Errors and possible causes Check the air circulation components for damage at least twice a year. If there are any malfunctions, the Fresh & Smart must be separated from power by pulling the CEE power plug. - Page 16 SALVIS AG Nordstrasse 15 CH-4665 Oftringen Phone +41 62 788 1818 +41 62 788 1895 www.salvis.ch info@salvis.ch...
Need help?
Do you have a question about the Fresh & Smart 1100 and is the answer not in the manual?
Questions and answers