Locking The Player; Special Settings In Test Mode; Commercial Player Spa Modes; Stop Spa Option - Heat Siphon Z Series Owner's Manual

HEAT SIPHON
4. If you are in COOL mode the lower right-hand corner of the display will have a red dot on all the time to
show that you are in COOL mode. The same applies to COOL mode while in DUAL mode.

4.4 Locking the Player

1. To lock the Player, press and hold both arrow keys until you see LOC on the display (six seconds), then
release both keys.
2. Three seconds after you release, LOC will be accepted with an audible beep.
3. Your keys are now locked. The display will continue to show the current Temperature/set point loop and
continue to heat your pool or spa as needed, however any keypress will show LOC on the display.
4. To unlock the Player, simply press and hold both arrow keys for six seconds until you hear a beep, then
release both buttons
5. The Player is now unlocked

5 Special Settings in TEST mode

For some special cases the Heat Siphon Player has two Spa settings. These are in the Test Mode They are listed
below and should only be enabled by the dealer:
1. C-SPA setting - In the case of a remotely heated spa where the plumbing run is long ands
thus the spa water temperature drops a few degrees before it gets to the Heat Siphon the
set point may need to be reduced to prevent overheating due to a phenomenon called
THERMOSTAT SET POINT DEPRESSION - SEE APPENDIX D of this manual for details.
2. H-SPA setting - The default maximum spa set point from the factory is 102°F. You may
change this to 103 or 104°F using this setting HOWEVER, be sure to read the SPA HEATING
cautions in Appendix D of this manual before using this option.
To enable these features ask your DEALER or CALL THE FACTORY.

6 Commercial Player Spa Modes

For spas in condominium/home owners associations, rental houses, hotels and other commercial applications,
Heat Siphon Player provides an additional feature to help a non-resident or absentee owner with the ability to manage
energy use when heating a stand alone spa. This is the S-SPA menu for Stop Spa Mode which includes Timed Spa
Heating Mode or "tSPA" as it appears on the 7 segment 4 digit LED.
S-SPA Menu is designed to limit the amount of time the Heat Siphon will stay in the SPA Mode (heating to the
SPA set point), after which Heat Siphon will revert back to the POOL Mode and heat to its set point.

6.1 STOP SPA Option

The hours chosen in the STOP SPA or S-SPA menu (0 , 2, 4, 6 or 8 Hours and Timed SPA or "tSPA"). You can
choose S-SPA menu is accessed as
1. holding down both keys until SSPA is displayed.
2. Release both keys and use the up or down arrow keys to scroll through the options
3. Options are as follows:
"0" - Stop SPA Off - Normal Switching between POOL and SPA required
Digital Player Section
®
Digital Player - 42