Led Status Lights - Heat Siphon Z Series Owner's Manual

HEAT SIPHON
mode, then following message is displayed:
Screen Message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Duration
POOL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (2 second)
78°F . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (2 second)
HEAT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (1 second)
SET. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (1 second)
88°F . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (2 second)
If errors occur or event timers are active they take precedent. All common Error codes are listed on the decal
along with their meaning.
One of the timers that you will see is the Off timer. This is a 240 second (4 minute) countdown that will occur
anytime the Heat Siphon turns off either in the background or shown directly on the display. This is a safety
feature that allows the internal pressures to equalize before restarting. You will see it as, OFF, 239, 238, 237, 236,
OFF, 234, 233 etc.
Another timer you will see is the FLO timer. This is a 15 second timer that begins when the water pump turns on.
This is to give the water pump time to push all the bubbles through the system and achieve good water flow before the
Heat Siphon turns on. You will see it as, FLO, 14, 13, 12, 11, FLO, 9, 8, 7, 6 etc. Modes: (POOL, SPA, AUTO PIC, OFF)

1.2 LED STATUS Lights

The Player has 4 LED lights located just above the top of the 4 digit display window which are labeled from left
to right :
BLUE LED - Wireless PumpJump™ flutters blue when a wireless accessory is attached and communicating
to a PassPort OR is solid ON when timeclock over-ride is activated using a hardwired T type or S-Type POD (Pool
Operating Device)
RED LED - Service blinks when an error is detected and service call is required or an error /warning requiring
user intervention has been detected
GREEN LED - Signifies the Player is in POOL MODE or in AUTO-PIC Mode with POOL Selected and is heating
your water to the POOL set point
YELLOW LED - signifies the Player is in SPA MODE or in AUTO-PIC Mode with SPA Selected and is heating
your water to the SPA set point
The GREEN (pool) and YELLOW (spa) LED's also signifies what "state" the Player is in based on what
they are doing:
LED ON SOLID that means the pool or spa is at temperature and READY to use.
LED IS BLINKING SLOWLY (1 second on/off) indicates that the Player is heating your pool or spa but
has not yet reached temperature.
LED IS FLASHING RAPIDLY (1/2 second on 1/2 second off) indicates the Player is waiting to change
state such as when a countdown timer is active but your Heat Siphon has not yet turned on.
Digital Player Section
®
Digital Player - 36