Dometic PERFECTVIEW VS400N Installation And Operating Manual page 14

Installing the video splitter
To establish and test the electrical connection, the following tools are required:
See fig. 4, page 5
• Diode test lamp (8) or voltmeter (9)
• Crimping tool (10)
• Insulating tape (11)
• If applicable, cable bushing sleeves
To secure the control unit and the cables, you may require additional screws and cable ties.
!
CAUTION!
Select the location of the modules so that they cannot injure the passengers in the vehi-
cle under any circumstances (e.g. sudden braking, traffic accidents).
Note the following instructions during installation:
• The installation location must be protected from moisture and be inside the vehicle.
• The installation location should be flat.
• Before drilling each hole, ensure there is sufficient space on the other side for the drill head to
emerge (fig. 5, page 6).
To perform the installation, proceed as follows:
➤ Attach the control unit and the operating unit to their respective installation location provision-
ally.
➤ Install the reversing video system if you have not already done so.
➤ Start up the reversing video system.
If transmission of the camera image is stable, you can carry out the final installation of the con-
trol unit and operating unit.
6.2 Installing the operating unit
I
NOTE
Make sure the adhesive surfaces (surface and bottom of the unit) are clean, dry and free
of grease.
Proceed as follows:
➤ Glue the Velcro strip to the bottom of the operating unit.
➤ Glue the matching Velcro strip to a suitable position in the vehicle (fig. 6, page 6).
➤ Affix the operating unit.
14
VS400N
EN