Dometic PERFECTVIEW VS400N Installation And Operating Manual page 16

Connecting electrical power to the video splitter
7.2 Connecting the control unit
➤ Connect this connection (fig. 2 3, page 3) to the operating unit.
➤ Connect this connection (fig. 2 4, page 3) to the monitor.
➤ Connect the camera connections (fig. 2 1, page 3) to the cameras.
➤ Continue with the setup as described in the following chapter (chapter "Connecting the cable
set" on page 16).
7.3 Connecting the cable set
The cable set features the following connections:
No. in
fig. 0, page 7
1
2
3
4
5
6
7
See fig. 0, page 7
➤ Connect the plug on the cable set (1) to the socket of the control unit (fig. 2 2, page 3).
➤ Connect the green cable (2) to the positive wire (+) of the reversing light (camera 1).
➤ Connect the white cable (3) to the control signal for camera 2.
➤ Connect the blue cable (4) to the control signal for camera 3.
➤ Connect the brown cable (5) to the control signal for camera 4.
➤ Connect the black cable (6) to the earth wire (–) or to earth (bodywork).
➤ Connect the red cable (7) to the positive wire (+) of the vehicle.
7.4 Switching camera inputs on and off
With the on/off switches (fig. 2 4, page 3) on the control unit, the camera inputs are switched on
and off. When the camera input is switched off, it is skipped and an empty screen is avoided.
16
Explanation
Plug for the control unit, 6-pin
Control input for reversing light (camera 1), green
Control input for camera 2, white
Control input for camera 3, blue
Control input for camera 4, brown
Earth connection –, black
12 V connection +, red
VS400N
EN