THOMSON Speedtouch 600 Series Orientation Manual page 52

3 The SpeedTouch™610 Web Interface
48
•
Click the Address Pools tab to configure the SpeedTouch™610 DHCP
server lease pool properties:
The SpeedTouch™610 DHCP server (if enabled) will use the address pools
listed in this table to provide IP addresses to requesting DHCP clients. If
needed, you can add/delete DHCP address pools manually.
• Click the DHCP Relay tab to view the DHCP Relay pages. This page is subdivided
into two parts:
•
Click the Relay Config tab to view the current SpeedTouch™610 DHCP
relay status:
Via this table you can also manually add static SpeedTouch™610 DHCP relay
entries for specific interfaces, if applicable.
•
Click the Relay Interfaces tab to view the SpeedTouch™610 DHCP relay
interfaces:
E-SIT-CTC-20030306-0004 v2.0