Playing A Tape - Sony CMT-J3MD Operating Instructions Manual

To Do this
Press s.
Stop play
Press MD HS. The indicator on
Pause
the MD HS button lights orange.
Press again to resume play.
Select a track Press lm or ML
repeatedly.
Keep pressing lm or
Find a point in
ML during play and release it
a track
at the desired point.
Remove the MD Press MD A.
Adjust the Turn VOLUME.
volume
Tips
• You can start playing from the desired track in
step 2.
1 Press lm or ML repeatedly until the
desired track appears.
2 Press MD HS.
Or, press the number buttons on the remote.
The playback automatically starts. To enter track
numbers 10 or over, press >10 (press twice to enter
100 or over), then press the track number. To enter
0, use the 10/0 button.
• Pressing MD HS when the system is off
automatically turns on the system and starts MD
play if there is an MD in the system (One Touch
Play).
• You can switch from another source to the MD
deck and start playing an MD just by pressing MD
HS (Automatic Source Selection).
Note
Do not use an MD on which the label sticks out from
the edge or on which the label is not positioned
correctly. Such labels can cause the MD deck to
malfunction.

Playing a tape

You can use any type of tape, TYPE I (normal),
TYPE II (CrO ) or TYPE IV (metal), since the
2
tape deck automatically detects the tape type
1
(ATS* ).
To turn on the system, press ?/1 (power).
1
* ATS: Automatic Tape Selection.
?/1 (power)
lm/ML
s
`/1
HS
h
S TAPE TAPE h 3
1
Press to open the cover and insert a
recorded tape.
With the side
you want to
play facing
up
VOLUME
M
l m L
A
HS
H
A
DOLBY 2 4
NR
L
M
m
l
continued
15