IBM System/36 Maintenance Information Manual page 96

6. Twinaxial Cable:
Ensure the cable is attached to a work station. If the Cable Thru feature is present, ensure the cable is
attached to the last work station on the port and set the terminator switch on the last work station to 1.
To check a cable not attached to a work station, terminate the end of the cable with a resistor assembly
(part 7362344) as shown here:
Phase 8
Phase A
Shield
>
~
55 Ohms
55 Ohms
;
R36B118-0
Go to step 8 on page 7-7.
7-6
5363 Maintenance Information