Table of Contents
Advertisement
Symptom
Information
Action
The control panel is not operating,
The CSP can be in a
Perform the following to stop the
and the system appears to be
program loop while
program loop:
stopped.
performing a control
1.
Set the Power Switch to the Off
panel instruction.
(0) position.
2. Wait 5 to lO seconds.
3. Set the Power Switch to the On
(I)
position.
4.
Load the system from disk and run
SYSTEST, see "328 Service
Procedures under SSP" on
page 3-lO to verify correct
operation.
Section 5. Control Panel Procedures
5-3
Hide quick links:
Advertisement
Chapters
Table of Contents
