Binary Synchronous Communications Jumper Setup - IBM System/36 Maintenance Information Manual

988 Binary Synchronous Communications Jumper Setup
Install the jumper on P3.
• Installing the jumper on pins 2 and 4 selects the
primary
BSC adapter mode.
• Installing the jumper on pins I and 3 selects the
alternate
BSC adapter mode.
• Connectors PI and P2 must have jumpers as shown for correct operation of the adapter.
Note: If you also have an SDLC adapter installed, you must set P3 as primary.
• The card is now ready to be installed in the machine.
Primary BSC
Adapter Jumper
Position
P3
9-14
5363 Maintenance Information
Connectors P1 and P2
have jumpers as shown
for correct operation
of the adapter.
R36D112-2