IBM System/36 Maintenance Information Manual page 85

510 Control Panel Removal
1.
Power off the 5363.
2. Remove the covers ("305 Cover Removal" on page 3-2).
3. Support the control panel from the front of the system. Remove the two mounting screws that attach the
control panel to the frame. You can reach the screws from inside the system.
4. Disconnect the three wires to the Security switch:
Black wire to position I
Red wire to position 3
White wire to position 5
5. Carefully lift each of the two latches on the bottom of the bezel. Lift each latch only enough to release
the bottom of the control panel, then remove the bezel.
6. Disconnect JCI.
7. Install the control panel by doing the previous steps in reverse order.
Section 5. Control Panel Procedures
5-9