1
I
NTRODUCTION
1.1
Microx Online Analyser
The Microx Online is a wall or surface mounting instrument is for the
measurement of % Oxygen volume levels taken from a process line.
Typically the sample source would indicate the Oxygen level in the related
process and the Microx Online would be configured to initiate an Alarm
condition if the Oxygen content measured is too high.
This can be typically be for process purity reasons such as in Nitrogen
generation processes. Thus the inverse of the Oxygen measurement can also
indicate the level of Nitrogen in the process being measured.
Key design features are:
•
Sturdy compact enclosure
•
Simple keypad calibration facility (utilising onboard LCD display).
•
4-20mA current source output for gas level indication (10-bit
resolution).
•
230VAC or 24VDC power supply
•
RS232 output for transmission of live data to a PC.
•
Status indicating light tower for audible/visual warning as an
option.
The Sample gas is supplied from( and exhausted to*) the sample location to
the via pipework provided and installed by the customer.
This sample gas is supplied under small positive pressure which can be
regulated down to a suitable level via the Regulator device within the Microx
Online Analyser.
The Sample gas then enters (and leaves) the Microx Online via integral 6mm
Bulkhead fittings.
*Alternatively, The Exhausted sample gas can be piped to a suitable vent
location.
Note! This Instrument is for Safe, Non-Hazardous(Non-Ex) locations of
operation only.
Issue:
1.14
Rev. 1.0
Page 1