Menu 6 - Sensor Selection; Menu 7; Menu 8 - Diagnostics - Ntron Microx Online User Instruction Manual

Menu 6 – Sensor selection
4.1.6
The Gasenz is supplied configured for the Sensor type with which it is
Customer adjustment of this setting is not permitted.
4.1.7
Adjusting this setting will render the Gasenz inoperable.
4.1.8
4.1.9
4.1.7

Menu 7

Customer adjustment of this setting is not permitted. The module will be
factory set prior to shipment at "0". Changing this value may limit the
performance and, in extreme cases, the instrument may no longer detect
4.1.8

Menu 8 - Diagnostics

This feature is a view-only feature. No configuration changes are possible from
within this menu.
•
Press the MENU button to open the menu system.
•
Using the NEXT and PREVIOUS buttons select menu option:
E:8
•
Press ENTER.
•
The display will alternate between the current value and
diagnostic code E:8x: where x is:
0
1
2
3
•
The diagnostic code can be selected by pressing the UP button.
•
Press MENU to return the instrument to its standard mode of
operation.
Issue:
Warning
to be used.
Warning
gas.
Sensor signal, A to D counts low ppm range.
Sensor signal, A to D counts high ppm range.
Sensor signal, A to D counts %vol range.
Firmware version.
1.14 Rev. 1.0 Page 17