Listening To The Radio; Preset Tuning - Sony CMT-CPZ1 Operating Instructions Manual

To change the AM tuning interval
(except for European model)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding
TUNING +, press ?/1 on the unit. When you
change the interval, all the AM preset stations
are erased. To reset the interval, repeat the same
procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode (page 24).
Tips
• The preset stations are retained for about half a day
even if you disconnect the mains lead or if a power
failure occurs.
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
To improve tuner reception
When tuner reception is poor, set CD player
power off by CD power manage function.
CD power is factory set to on.
Use buttons on the unit for the operation.
1
Press FUNCTION repeatedly to switch the
function to CD.
2 Press ?/1 to turn off the system.
After "STANDBY" stops flashing, press ?/1
3
while holding CD x.
"CD POWER" and "OFF" appear.
To set CD power on
Repeat the procedure above and "CD POWER"
and "ON" appear.
Notes
• When "CD POWER" and "OFF" are selected, disc
access time is increased.
• You cannot change the setting in Power Saving
Mode (page 24).
GB
16

Listening to the radio

You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station

— Preset Tuning

Preset radio stations in the tuner's memory first
(see "Presetting radio stations" on page 15).
1
Press TUNER BAND (or FUNCTION
repeatedly) to switch the function to
TUNER.
2
Press TUNER BAND repeatedly to
select "FM" or "AM".
3
Press TUNING MODE repeatedly until
"PRESET" appears in the display.
4
Press + or – (or TUNING + or – on the
unit) repeatedly to select the desired
preset station.