Searching For Tracks With The Jog Dial - Sony CMT-CPZ1 Operating Instructions Manual

Other operations
To
Stop play
Pause
Select a track
Select a group on
the ATRAC CD
or MP3 CD
Find a point in a
track
Remove a disc
Notes
• You cannot change the play mode during playback.
• Some time may be needed to start playback of discs
recorded in complex configurations such as many
layers.
• Before playing back a track, the system reads all
tracks and groups on the disc. During this time,
"READING" appears on the display. Depending on
the disc content, some time may be needed to read
the disc.
• A group that does not include MP3 tracks is skipped.
• Depending on the encoding/writing software,
recording device, or the recording media used at the
time an MP3 track is recorded, you may encounter
such problems as disabled playback, sound
interruptions, and noise.
• When playing back an MP3 track, the playback
elapsed time indication may differ from the actual
time in the following cases.
– When you play back a VBR (variable bit rate)
MP3 track
– When you perform fast forward or rewind (Manual
Search)
Tip
When disc access takes a long time, set "CD POWER"
and "ON" by CD power manage function (page 16).
GB
12
Do this
Press x (or CD x on the unit).
Press X (or CD NX on the unit).
Press again to resume play.
Press . or > repeatedly.
Press + or – repeatedly after
step 2.
Keep pressing m or M during
playback and release it at the
desired point.
Press CD Z on the unit.
Searching for tracks with
the jog dial
You can quickly search for and play the desired
track by using the jog dial on the unit.
Use buttons on the unit for the operation.
1
Press FUNCTION repeatedly to switch
the function to CD.
2
Turn the jog dial in stop mode to select
the desired track, then press PUSH
ENTER.
To search for tracks on the ATRAC CD or
MP3 CD, turn the jog dial to first select the
desired group, then press PUSH ENTER
before performing step 2.
Playback starts from the selected track.
Note
Only the first 6 characters are displayed when
performing the group or track search.
Tip
You can search for and play other tracks in the selected
group during playback. To select a track of another
group during playback, turn the jog dial
counterclockwise until "GROUP" appears, then press
PUSH ENTER and select a group. You can then select
the desired track by turning the jog dial.
To cancel the track search
Press CANCEL.
Notes
• If you do not perform any operations for
approximately 8 seconds, the display returns to the
previous one.
• The track search is not possible in Program Play
mode.