Connecting Optional Components - Sony CMT-CP1 Operating Instructions Manual

Step 3: Presetting radio stations
(continued)
To tune in a weak station
In step 3, press TUNING MODE (or
TUNING/PLAY MODE on the remote)
repeatedly until "AUTO" and "PRESET"
disappear, then press TUNING +/– (or
j/J on the remote) repeatedly to tune in
the station.
To change the preset number
Start over from step 2.
Tip
The preset stations are saved in the system's
memory for about two days even if you disconnect
the power cord or a power failure occurs.
To change the AM tuning interval
(not applicable on the European
and Middle Eastern models)
The AM tuning interval is factory-preset to 9 kHz
(or 10 kHz on North American model). To switch
the AM tuning interval, tune in any AM station first,
then turn off the system. Pressing TUNING + down,
turn the system back on. When you change the
interval, all the AM preset stations are erased. To
change back to the original interval, repeat the same
procedure.
8
Connecting optional
components
This section explains how to connect a variety
of components to your system in order to
enhance it. Refer to the instructions included
with each component for details.
Connecting audio
components
Connecting an MD deck for analog
recording
You can connect an MD deck to the system
with commercially available audio cords. Be
sure to match the color-coded pins to the
appropriate jacks. To listen to the MD deck
after connecting it, press MD/VIDEO until
"MD" appears.
To the audio input jacks on
the MD deck
To the audio output jacks on the
MD deck