Specifications - Sony CMT-CP1 Operating Instructions Manual

Tuner
There is a severe hum or noise ("TUNED"
or "STEREO" flashes).
• Adjust the antenna.
• The signal strength is too weak. Connect
an external antenna (see page 9).
• Make sure that the antenna is connected
properly.
• Do not bend or roll up the antenna.
• The two wires comprising the FM
antenna have been pulled further apart
since the system was first purchased.
Repair or replace with a new one.
• The AM antenna wire is detached from
the stand.
A stereo FM program cannot be received in
stereo.
• Press STEREO/MONO on the remote
until "STEREO" appears in the display.
Resetting the system
1 Disconnect the power cord from the wall
outlet.
2 Press ?/1 down and connect the power
cord to the wall outlet again.
The system is reset to the factory settings. All
previous settings such as the preset stations,
clock, and timers are cleared and must be set
again.

Specifications

Amplifier section
For the U.S. model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6-ohm loads both channels driven, from
70 - 20,000 Hz; rated 18 watts per channel
minimum RMS power, with no more than
0.9% total harmonic distortion from
25 milliwatts to rated output.
North American model:
Continuous RMS power output (reference):
Total harmonic distortion less than 0.07% (6 ohms at
1 kHz, 18 W)
European model:
DIN power output (rated): 20 + 20 W
Continuous RMS power output (reference):
Music power output (reference):
Other models:
The following measured at 230 V AC, 60 Hz
DIN power output (rated): 20 + 20 W
Continuous RMS power output (reference):
The following measured at 220 V AC, 60 Hz
DIN power output (rated): 18 + 18 W
Continuous RMS power output (reference):
Inputs
MD IN (phono jacks):
VIDEO IN (phono jacks): Sensitivity 500 mV,
Outputs
LINE OUT (phono jacks): Sensitivity 500 mV,
OPTICAL DIGITAL OUT (CD):
PHONES (stereo phone jack):
SPEAKER:
25 + 25 W
(6 ohms at 1 kHz, 10% THD)
(6 ohms at 1 kHz, DIN)
25 + 25 W
(6 ohms at 1 kHz, 10% THD)
85 + 85 W
(6 ohms at 1 kHz, DIN)
25 + 25 W
(6 ohms at 1 kHz, 10% THD)
(6 ohms at 1 kHz, DIN)
23 + 23 W
(6 ohms at 1 kHz, 10% THD)
Sensitivity 1,000 mV,
impedance 47 kilohms
impedance 47 kilohms
impedance 1 kilohm
Optical
Accepts headphones with
an impedance of 8 ohms
or more
Active speaker system,
6 ohms
continued
33