Connecting Optional Av Components - Sony lbt-g2500 Operating Instruction

Step 3: Presetting radio stations
(continued)
To tune in a station with a weak
signal
Press TUNING MODE repeatedly in step 2
until "MANUAL" appears, then press
TUNING +/– to tune in the station manually.
To change the preset number
Start over from step 1.
To change the AM tuning interval
(for models with the AM TUNING STEP
switch on the rear panel)
The AM tuning interval is factory-preset to
9 kHz (10 kHz in some areas). To change the
AM tuning interval, turn off the power and
set the AM TUNING STEP switch on the rear
panel to 10 kHz (or 9 kHz). Then turn the
power back on. When you change the
interval, all the preset stations will be erased.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
8
Connecting optional
AV components
To enhance your system, you can connect
optional components. Refer to the
instructions included with each component
for details.
Connecting a turntable
Be sure to match the color of the plugs and
the connectors. To listen to the sound from
the connected turntable, press PHONO.
To the audio output of the turntable
Note
Using the turntable at high volume may cause
distortion or howling. This is often caused by the
bass sound from the speakers. The bass sound may
be picked up by the needle of the turntable, and
produce the distortion or howling. To avoid this, do
the following:
1 Keep some distance between the speakers and the
turntable.
2 Stop using the surround effect.
3 Install the speakers or the turntable on a firm and
stable surface.
4 Press DBFB repeatedly until "DBFB
disappears from the display.
"