Singer Instruments ROTOR HDA User Manual page 18

software icon guiDe
AdVANce OPTiONs
IcOn nAME SETTIng
recycle Off
recycle Full
recycle Until
repeat
recycle during
Pairs
revisit On/Off
source
Plate On/Off
Protection
repeat On/Off
Pairs
Offset Off
Offset Automatic
Offset random
18
DEScrIPTIOn
rePads™/pins are always dumped.
rePads™/pins are recycled for the
duration of the program.
rePads™/pins are recycled for the
duration of one cycle of the program.
rePads™/pins are recycled for the
duration of each pinning pair.
revisit ensures that the source is
revisited for each pinning. if revisit
source if off, the source plate will not
be revisited unless a new position on
the source plate is being pinned.
By protecting the source plates you
can ensure that lids are only removed
when it is vital to do so. This will
increase the time it takes to run each
program, but each source plate will
be exposed for less time, and the
print head will never move over a
source plate without a lid on, unless
it is pinning from it
A pinning pair represents pinning
from a source plate to a target plate.
you can adjust how many times
each of these pairs are repeated.
during pair repetition, recycle and
revisit mode rules will be followed
as normal.
No offset is used for source pinning.
An automatic offset is used for each
source pinning.
A random offset is used for each
source pinning.
TAb UnIT
General>recycle N/A
General>recycle N/A
General>recycle N/A
General>recycle N/A
General>recycle Boolean
General>Plate Boolean
Protection
General>Pairs Boolean
source>Offset Boolean
source>Offset Boolean
source>Offset Boolean
MIn MAx DEFAUlT
N/A N/A N/A
N/A N/A N/A
N/A N/A N/A
N/A N/A N/A
Off On Off
Off On Off
Off On Off
Off On Off
Off On Off
Off On Off