flsun C-PLUS Manual page 3

Important Note
A,when use switch power supply,If your country AC voltage is
220V,pls choose 220V;if it's110V,pls choose 110V,there is one adjust
button on the switch power supply.
B, when heating the nozzle or printing,for the fan which cooling heat
sink,guarantee it working,if not,pls stop heating and printing.
C,the temperature is a important parameter, for PLA filament, the
working temperature is 200℃-210℃, you could adjust it,and the
temperature should not too high.too high temperature maybe lead to
Nozzle clogging.
D,Before printing, please paste high temperature tape on the hot bed
E,If you have installed the touch screen ,pls choose PC or touch
screen to make a Single control
F,If you need to upload marlin ,when you upload ,pls disconnect the
touch screen with the motherboard
- 3
-