Direct Tuning - Sony STR-DG2100 Operating Instructions Manual

Direct tuning

Enter the frequency of a station directly by
using the numeric buttons.
1
Make sure that the AMP button
is lit.
If it is not lit, or "GUI MODE" is not
displayed in the display window of the
receiver, follow the steps given in "7:
Operating the receiver using the GUI
(Graphical User Interface)" (page 38).
2
Press V/v repeatedly to select
"FM" or "AM," then press
b.
3
Press V/v to select "Direct
Tuning," then press
80
GB
4
1
4
2-4
If you cannot tune in a station
"– – – .– – MHz" appears and then the display
returns to the current frequency.
Make sure you have entered the right
frequency. If not, repeat step 4. If you still
cannot tune in a station, the frequency is not
used in your area.
or
.
Press the numeric buttons to
enter the frequency, then press
to enter.
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
Tip
If you have tuned in an AM station, adjust
the direction of the AM loop antenna
(aerial) for optimum reception.