Remote Control; Error Messages - Sony STR-DG2100 Operating Instructions Manual

Hi-fi receivers: multi channel a/v receiver
Hide thumbs Also See for STR-DG2100:
Table of Contents

Advertisement

(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground (earth) wire to a gas pipe.
Outdoor FM antenna (aerial)
Receiver
Ground (earth)
wire (not supplied)
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• Keep the satellite radio antenna, away
from the speaker cords and the power cord
to avoid picking up noise.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 81).
• Press DISPLAY so that the frequency
appears on the display.
The system cannot receive satellite
channels at all.
• The receiving condition is not good. Move
the antenna to the place where the
condition is good.
• Check that you subscribed to the desired
satellite radio service (see page 82).

Remote control

The remote does not function.
• Point the remote at the remote sensor on
• Remove any obstacles in the path between
• Replace all the batteries in the remote with
• Make sure that the command modes of the
• Make sure you select the correct input on
To ground
• When you operate a programmed non-

Error messages

If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
PROTECTOR
Irregular current is output to the speakers, or
the upper panel of the receiver is covered
with something. The receiver will
automatically turn off after a few seconds.
Check the connection of speakers and turn
on the power again.
For other messages, refer to "Message list after
auto calibration measurement" (page 48),
"XM Radio message list" (page 89), "SIRIUS
Satellite Radio message list" (page 89) and
"DIGITAL MEDIA PORT message list"
(page 94).
the receiver.
the remote and the receiver.
new ones, if they are weak.
receiver and the remote are the same. If the
command mode of the receiver and the
remote are different, you cannot operate
the receiver with the remote (page 37).
the remote.
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
continued
127
GB

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents