Attaching the monitor stand
IMPORTANT:
of color or disorientation of the liquid crystals. If this occurs, the screen will not recover to its normal
condition.
1.
Lay the monitor head facedown on a flat surface covered by a clean, dry cloth.
2.
Slide the top of the mounting plate on the stand under the upper lip of the recess in the back of the
panel (1).
3.
Lower the bottom of the stand's mounting plate into the recess until it snaps into place (2).
4.
The latch pops up when the stand is locked in place.
Removing the monitor stand
You can remove the monitor head from the stand to install the monitor head on a wall, a swing arm, or other
mounting fixture.
CAUTION:
are disconnected.
1.
Disconnect and remove all cables from the monitor.
2.
Position the monitor facedown on a flat surface covered by a clean, dry cloth.
3.
Push up on the latch (1) on the monitor stand.
16
Chapter 1 Getting Started
Do not touch the surface of the LCD screen. Pressure on the screen may cause nonuniformity
Before beginning to disassemble the monitor, be sure that the monitor is turned off and all cables