Table of Contents
Advertisement
To reconfigure Function buttons:
1.
Press one of the four front panel Function buttons to activate the buttons, and then press the
button to open the OSD menu.
2.
In the OSD menu, select Menu Control, select Assign Buttons, and then select one of the available
options for the button you want to reassign.
NOTE:
To view an OSD menu simulator, visit the HP Customer Self Repair Services Media Library at
http://www.hp.com/go/sml.
Rear and side components
Table 1-7
Rear and side components and their descriptions
Component
1
Power connector
2
DisplayPort port
3
HDMI port
4
VGA port
5
USB Type-B port
(upstream)
6
USB Type-A ports (2)
(downstream)
Setting up the monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, and then follow the instructions below.
Use caution when setting up the monitor
To prevent damage to the monitor, do not touch the surface of the LCD screen. Pressure on the screen may
cause nonuniformity of color or disorientation of the liquid crystals. If this occurs, the screen will not recover
to its normal condition.
Function
Connects a power cord.
Connects a DisplayPort cable to the source device.
Connects an HDMI cable to the source device.
Connects a VGA cable to the source device.
Connects a USB Type-B cable to a source device to enable the monitor USB
hub.
Connect USB devices to the monitor USB hub.
Menu
Setting up the monitor
11
Advertisement
Table of Contents
