Function For Conversion Of Video Signals - Sony STR-DA7100ES Operating Instructions Manual

Video INPUT/OUTPUT jack to be
connected
The image quality depends on the connecting
jack. Refer to the illustration that follows.
Select the connection according to the jacks on
your components.
TV monitor etc., INPUT jack
Receiver MONITOR OUT jack
Receiver INPUT jack
Video component OUTPUT jack
Notes
• Connect image display components such as a TV
monitor or a projector to the MONITOR OUT jack
on the receiver. You may not be able to record, even
if you connect the recording components.
• Turn on the receiver when the video and audio of a
playback component are being output to a TV
through the receiver. If the power supply of the
receiver is not on, neither video nor audio is
transmitted.
Function for conversion of
video signals
This receiver is equipped with a function for
converting video signals. You can output the
COMPONENT
HDMI
VIDEO
COMPONENT
HDMI
VIDEO
Signal
processing
COMPONENT
HDMI
VIDEO
COMPONENT
HDMI
VIDEO
High quality image
video signal after connecting this receiver via
the MONITOR OUT jack as shown in the
illustration.
• Video signals can be output as HDMI video,
component video and S-video signals.
• S-video signals can be output as HDMI
video, component video and video signals.
• Component video signals can be output as
HDMI video, S-video and video signals.
You can switch the function for converting
video signals ON/OFF in VIDEO CONVERT
(page 71). The initial setting is "ON." When
VIDEO CONVERT is set to "OFF," the video
signals are not converted.
S-VIDEO VIDEO
S-VIDEO VIDEO
S-VIDEO VIDEO
S-VIDEO VIDEO
continued
33 GB