3A: Connecting The Audio Components - Sony STR-DA7100ES Operating Instructions Manual

3a: Connecting the audio components

How to hook up your
components
This section describes how to hook up your
components to this receiver. Before you begin,
refer to "Component to be connected" below
for the pages which describe how to connect
each component.
Component to Super Audio CD player/ CD
be connected player
MD/DAT
Tape deck, Analog disc turntable
a)
Model with a DIGITAL OPTICAL OUTPUT or DIGITAL COAXIAL OUTPUT jack, etc.
b)
Model with MULTI CH OUTPUT jacks, etc. This connection is used to output audio decoded by the
component's internal multi-channel decoder through this receiver.
c)
Model equipped only with AUDIO OUT L/R jacks, etc.
If you have Sony components with
CONTROL A1II/CONTROL S jacks
See "Operating Sony components" on page
87.
24
GB
After hooking up all your components,
proceed to "4: Connecting the antennas" (page
43).
With digital audio output
With multi-channel audio output
With i.LINK jack
With analog audio output only
With digital audio output
With analog audio output only
a)
page 26
b)
page 28
page 29
c)
page 31
a)
page 26
c)
page 31
page 31