4A: Connecting The Audio Components - Sony R-DG1200 Operating Instructions Manual

Notes
• Be sure to turn on the receiver when the video and
audio signals of a playback component are being
output to a TV via the receiver. Unless the power is
turned on, neither video nor audio signals will be
transmitted.
• Depending on the status of the connection between
the TV and the antenna, the image on the TV
screen may be distorted. In this case, place the
antenna farther away from the receiver.
• When connecting optical digital cords, insert the
plugs straight in until they click into place.
• Do not bend or tie optical digital cords.
Tips
• The receiver has a video conversion function. For
details, see "Notes on converting video signals"
(page 31).
• The sound of the TV is output from the speakers
connected to the receiver if you connect the audio
output jack of the TV and the TV IN jacks of the
receiver. In this configuration, set the audio output
jack of the TV to "Fixed" if it can be switched
between either "Fixed" or "Variable".
• The screen saver is activated when the GUI menu
is displayed on the TV screen and there has been no
operation attempted for 15 minutes.
• All the digital audio jacks are compatible with
32 kHz, 44.1 kHz, 48 kHz, and 96 kHz sampling
frequencies.
US
18
4a: Connecting the audio
components
How to hook up your
components
This section describes how to hook up your
components to this receiver. Before you begin,
see "Component to be connected" below for
the pages which describe how to connect each
component. Before connecting the cords, be
sure to disconnect the AC power cord.
After hooking up all your components,
proceed to "5: Connecting the antennas"
(page 33).
Component to be connected
Super Audio CD With digital audio
player, CD player output
With multi channel
audio output
With analog audio
output only
MD deck With digital audio
output
With analog audio
output only
Tape deck, Analog disc turntable
DIGITAL MEDIA PORT adapter
Notes
• When connecting optical digital cords, insert the
plugs straight in until they click into place.
• Do not bend or tie optical digital cords.
Tip
All the digital audio jacks are compatible with
32 kHz, 44.1 kHz, 48 kHz, and 96 kHz sampling
frequencies.
Page
19
21
22
19
22
22
19