Tv And Video Component Hookups; Required Cords; Jacks For Connecting Video Components - Sony DAV-S300 Operating Instructions Manual

TV and Video Component Hookups

Required cords

Video cord for connecting a TV monitor (supplied)
Yellow
Audio/video cords (not supplied)
When connecting a cord, be sure to match the color-coded pins to
the appropriate jacks on the components.
Yellow (video)
White (L/audio)
Red (R/audio)

Jacks for connecting video components

Connect a
TV monitor
VCR
Additional VCR
z
When using the S-video jack instead of the video jacks
Your TV monitor must also be connected via an S-video jack. S-
video signals are on a separate bus from the video signals and
will not be output through the video jacks.
VIDEO OUT VIDEO IN
FM
75
AUDIO OUT AUDIO IN
COAXIAL
L
AM
R
IN
INPUT OUTPUT
VIDEO VIDEO
IN
AUDIO AUDIO
IN
Yellow
Yellow (video)
White (L/audio)
Red (R/audio)
To the
MONITOR OUT jack
VIDEO 1 jacks
VIDEO 2 jacks
VIDEO IN VIDEO
S VIDEO
FRONT R
( DVD ONLY )
AUDIO IN
L
R
REAR R
IMPEDANCE USE 3
OUT OUT
OUTPUT
VIDEO
OUT OUT
AUDIO
OUT OUT
L L
R R
VCR Additional VCR
Note
The VIDEO 1 AUDIO OUT L/R jacks output the same signal as
the front L/R speakers. When you select VIDEO 1 using the
FUNCTION button, the signal is output from the front L/R
speakers, but not from the VIDEO 1 VIDEO OUT and AUDIO
OUT L/R jacks.
Setups for the system
Some setups are necessary for the system depending on
the TV monitor to be connected.
If the color system of the TV is NTSC or DUAL
Since the color system of the system is set to NTSC, you
can use this system as it is.
If the color system of the TV is PAL
To set the system to PAL, turn on the system while
pressing the X button of the system. To reset to NTSC,
turn off the system and then turn on as described above.
CENTER FRONT L
WOOFER REAR L
IN
INPUT
VIDEO
IN
TV monitor
11