Getting Started; Unpacking - Sony DAV-S300 Operating Instructions Manual

Getting
Started
This section describes how to hook up
the system to the speakers, a TV
monitor with audio/video input jacks
and other video component. You
cannot connect this system to a TV
monitor which does not have a video
input connector. Be sure to turn off
the power of each component before
making the connections.

Unpacking

Check that you have the following items:
• AM loop antenna (1)
• FM wire antenna (1)
• Speakers (5)
• Subwoofer (1)
• Speaker cords (5 m x 4, 15 m x 2)
• Video cord (1)
• Remote commander (remote) RM-SS300 (1)
• R6 (size AA) batteries (2)
• Foot pads (24)
• Speakers - Connection and Installation (card) (1)
Inserting batteries into the remote
You can control the system using the supplied remote.
Insert two R6 (size AA) batteries by matching the + and –
on the batteries. When using the remote, point it at the
remote sensor g on the system.
z
You can control TVs using the supplied remote
See page 51.
Notes
• Do not leave the remote in an extremely hot or humid place.
• Do not use a new battery with an old one.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or lighting
apparatuses. Doing so may cause a malfunction.
• If you will not use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
7