Music Playback Via Bluetooth - Silvercrest SKHK 40 A1 Operating Instructions Manual

♦ To terminate the Bluetooth
Bluetooth
hold down the Bluetooth
2 seconds until the operating/charging LED
and blue alternately . The headphones are now in pairing mode
again .
♦ Alternatively, switch the headphones off as described above
to deactivate the Bluetooth
NOTE
► The next time you turn on the headphones, they will automat-
ically connect to the last Bluetooth
was connected . If your Bluetooth
automatically reconnect to the headphones, you will have to
re-establish the connection manually . A detailed description of
how to do this can be found in the operating manual for your
Bluetooth
► If no Bluetooth
pairing mode ends and the headphones switch off automatically .
► Ensure that the headphones are no more than 10 metres away
from the Bluetooth
are no barriers or electronic devices placed between them .
As soon as you connect the AUX IN socket
►
cable , the Bluetooth
e
headphones change to AUX IN mode . The Bluetooth
can only be reactivated once you remove the audio cable
from the AUX IN socket

Music playback via Bluetooth

The following music playback functions are only available when the
headphones and the playback device are connected to each other
via Bluetooth
NOTE
► It may be the case that not all functions will be supported de-
pending on the playback device used and its operating system .
SKHK 40 A1
function on the Bluetooth
®
playback device .
®
connection can be made within 2 minutes,
®
playback device . Make sure that there
®
®
8
.
®
connection, either disable the
®
pairing button
®
function .
®
playback device that
®
playback device does not
®
function is deactivated and the
.
®
GB │ IE │ NI
playback device or
®
for about
4
flashes orange
0
to the audio
8
function
®
e
│ 11 ■