Power Supply Unit Leds Information; Speed Setting Button Information - FIAM. eTensil Use And Maintenance Manual

POWER SUPPLY UNIT LEDs INfORMATION

Colour Led
led 1 Green
led 2 Red
led 3 Red
led 4 Green
led h Green
led l Green
led s1 yellow
led s2 yellow
led s3
yellow

SPEED SETTING BUTTON INfORMATION

press this button to change from h (high speed) to l (low speed) and vice versa.
the tightening/untightening speeds can be set independently: to set the tightening
speed, set the tool to tightening and press the power supply unit button; to set the
untightening speed set the tool to untightening and press the button.
Clutch triggered, the tool has reached the set torque
motor stalled or pts released (lever start + push-to-start) in start mode
leveR +pts (lever start + push-to-start) or button +pts mode (lever
start + push-to-start)
external stop tool command (only on tpu 2 model, equipped with inputs/
outputs)
on light button
high tool speed
low tool speed
emergency input active (only on tpu 2 model, equipped with inputs/outputs)
tool connected and ready for use
tool rotating (Run)
function description
29