Range Specifications; Starting The Tool - FIAM. eTensil Use And Maintenance Manual

RANGE SPECIfICATIONS

MODEL
e8C5a-350
e8C4a-650
e8C3a-900
e8C3a-1200
e8C2a-2000
* fiam recommends that the screwdriver be used up to 80% of the maximum declared torque. take this
aspect into consideration depending on the job in question.
** the torque values shown refer to laboratory analysis based on iso 5393 standard with the screwdriver set
to maximum speed (hi). the torque values given are purely an indication.

STARTING THE TOOL

use only the material provided in the package. Do not use connection
cables other than those supplied by fiam.
1. Connect the tool power cable supplied first to the circular connector on the tool;
then, plug the other end of the cable into the socket on the front of the power sup-
ply unit.
2. plug the power cable for the supply unit into the socket on the back of the supply
unit.
then plug the product into the mains supply and switch it on.
alWays connect the screwdriver to the supply unit with the unit
switched off. failure to follow this rule could cause serious damage
to the tool or to the supply unit.
only connect the product to a properly earthed mains supply in ac-
cordance with the applicable laws. Do not use junctions or adaptors
that could interrupt the electrical continuity of the earth connection.
Do not use connection cables other than those supplied.
the standard length of the power cable (code 686903834) between the screwdriver
and the power supply unit is 3 m. the standard length of the cable from the supply unit
to the mains supply is 2 m. fiam recommends that these lengths be observed. other
connection lengths are not contemplated in the certification for this product. in addi-
tion, the system will not work if the screwdriver/supply unit connection exceeds 9 m.
TIGHTENING TORQUE [Nm]**
PART NO. min
111712004 0,6
111712003 0,6
111712002 0,6
111712001 0,6
111712000 0,6
MAX*
4,5
4
3,5
3
2,5
CAUTION!
IDLE SPEED [rpm]
HI LO
340 285
640 530
870 740
1180 980
2000 1650
23