Holding The Tool And Fitting It To The Reaction Arm - FIAM. eTensil Use And Maintenance Manual

HOLDING THE TOOL AND fITTING IT TO THE REACTION ARM

Fig. 1
before starting work, hold the tool firmly as shown in figure 1. for torques in excess
of 4nm clamp the tool to a reaction arm; the body of the tool can be clamped (figure
3) or the specific ring can be used (figure 2 code 6920779180).
the tool should be clamped as shown in the figures above.
Do not clamp the tool at other points because this could damage it and
compromise its working operation; in such case fiam cannot be held
responsible for any damage to the tool.
Fig. 2
Fig. 3
27