Before First Use; Temperature Scale, °F Or °C; Preset Temps Button; Manually Setting Temperature - Bonavita Interurban Series User Manual

BEFORE FIRST USE

1. Fill the kettle to 1.0L fill line with cold water then heat at the maximum boil
temperature setting.
2. Empty the kettle, and let the appliance cool down for one minute.
3. Repeat the same heating cycle written in the directions above once more and
rinse. Your kettle is now ready for use.
TEMPERATURE SCALE, ˚F OR ˚C
This product is pre-programmed to display °F settings. You have the capability of
switching to °C by holding down both - and + Buttons at the same time for three
seconds to switch between Fahrenheit and Celsius while the power is on.

PRESET TEMPS BUTTON

Immediately after turning kettle on, press the Preset Temps Button and continue
to press it until your desired preset temperature is displayed. If you would like
to see which temperatures are best for certain beverages, please checkout the
Recommended Temperatures table on page 15.
Please note: The Factory preset temperatures are: 140°F (60°C), 176°F (80°C),
185°F (85°C), 190°F (88°C), 205°F (96°C) and 208°F (98°C).
Please note: While these preset temperatures can't be reprogrammed, you can
manually set the kettle to a customized temperature by following the instructions in
Manually Setting Temperature below.

MANUALLY SETTING TEMPERATURE

1. Press the Power Button and the LED surrounding
the button will illuminate. The last temperature set
point flashes on the display.
Please note: Pressing the Hold Button while the
temperature flashes will maintain your selected
temperature for up to one hour (see Hold Button on
page 11 for more information).
2. Press or hold the - or + Button to select your
preferred temperature (Fig. 5).
3. Once the display stops flashing the temperature is set and the display shows
current water temperature. The kettle will now begin heating.
10
192F
Hold
5