Use E Reset - Montarbo WIND PRO Series Owner's Manual

Use e reset

The all new Montarbo® WIND PRO and EARTH PRO series is conceived
and developed to facilitate the technician during the connection and
setting process, making the best use of all the product potential.
In addition to the analogue inputs on XLR connectors, these new
loudspeakers feature two Ethercon inputs which, through a single
Cat 5E / 6 cable, allow the user to connect the system to the Dante
protocol, for transmitting the audio signal, and / or connect to the
Montarbo M-Connect and M-Modelling software for remote setting
and controlling each individual loudspeaker.
An integrated module also allows the loudspeaker - or loudspeaker
system - to be connected via WiFi.
Connection to the M-Connect software:
Make sure you have M-Connect software installed on your Pc / MAC.
Create a network with 1GBit certified router
Use a CAT 5E / 6 Lan cable for connection between the router and
one of the two Ethercon ports on the loudspeaker,
Turn on the loudspeaker.
Run the M-Connect software and start assigning the desired
parameters.
Connection to DANTE protocol:
Make sure you have Dante Controller software installed on your Pc
/ MAC and use an audio mixer with Dante card.
Create a network with 1GBit certified router,
Use a CAT 5E / 6 Lan cable for connection between the router and
one of the two Ethercon ports on the loudspeaker,
Turn on the loudspeaker.
Run the Dante Controller software and start assigning the desired
parameters.
WiFi connection:
Press the WiFi button on the loudspeaker until it starts to flash,
then release it. Make sure you have previously created a dedicated
accessible WiFi network.
Loudspeaker hardware RESET:
1 turn off the loudspeaker
2 while holding down the PRESET button, turn on the loudspeaker.
3 all LEDs will flash in 2 seconds after switching on
4 release the PRESET button then quickly press it again (1 click)
5 all LEDs will turn off
6 PRESET 1 LED will light on again
20 | Owner's manual | Series WIND PRO A
PUSH
INPUT
LIM/CLIP/THERMAL
GND
LIFT
WIFI SIGNAL
PUSH
PRIMARY SECONDARY
Tasto WiFi
POWER
LINK
PRESET
NETWORK
PUSH
SYNC
Tasto PRESET