Advertisement
5800 SERIES – DIRECT ELECTRICAL CONNECTION
Order separately the RAK4002B Kit. This kit must be used in
this application.
1. CONNECT THE CORDSET
Plug the connector, provided in the Direct Connect Kit, fully
into place in the unit mating connector. Be sure the locking
tabs at the sides are engaged.
Connector
2. ATTACH CONDUIT
1. Use the round knockout at the bottom of the junction
box to attach conduit coming from the branch circuit.
Remove the knockout, attach the conduit and bring
wires into the junction box. Leave 6" of wire free at the
end of the conduit to allow connections to be made.
2. If a fuse and fuseholder are to be used, the
knockout at the top of the box is for mounting a Buss
Fuseholder. Be sure the fuse and fuseholder are of the
same rating as the branch circuit. Leadwires at the
fuse can be either soldered in place or attached using
UL-listed 1/4" female (receptacle) crimp connectors.
Installation Instructions
Conduit
3. INSTALL JUNCTION BOX
• Install the junction box by engaging the tab at the lower
rear, aligning the screw hole at the top and driving the
one screw until secure. Be sure that all wire leads are
inside the box and not pinched between the box and
the unit. The green insulated ground wire from the unit
MUST be connected to the branch circuit ground wire.
Make all wire connections by using appropriate
UL-listed electrical connectors and techniques (black to
black, white to white and green to green).
4. INSTALL JUNCTION BOX COVER
1. Carefully tuck all wires and
connections back inside the
junction box. Be sure there are
no loose connections or stray
uninsulated wires exposed.
2. Place the junction box cover
in place. Replace the two
screws removed earlier and
tighten securely.
3. Discard the unused portion of the plug and the
cordset.
4. Replace the Zoneline front cabinet.
3
Advertisement
