Toshiba T300MV2 Instruction Manual page 11

Qualified Personnel
Installation, operation, and maintenance shall be performed by Qualified Personnel Only. A
Qualified Person is one that has the skills and knowledge relating to the construction, installation,
operation, and maintenance of the electrical equipment and has received safety training on the hazards
involved. In the U.S., refer to the latest edition of NFPA 70E for additional safety requirements. Outside the
U.S., follow all applicable national and local safety practices.
Qualified Personnel shall:
• Have read the entire operation manual.
• Be familiar with the construction and function of the ASD, the equipment being driven, and the
hazards involved.
• Able to recognize and properly address hazards associated with the application of motor-driven
equipment.
• Be trained and authorized to safely energize, de-energize, ground, lockout/tagout circuits and
equipment, and clear faults in accordance with established safety practices.
• Be trained in the proper care and use of protective equipment such as safety shoes, rubber
gloves, hard hats, safety glasses, face shields, flash clothing, etc., in accordance with established
safety practices.
• Be trained in rendering first aid.
For further information on workplace safety in the U.S. visit www.osha.gov. Outside the U.S.,
refer to your existing plant safety regulations.
Equipment Inspection
• Upon receipt of the equipment inspect the packaging and equipment for shipping damage.
• Carefully unpack the equipment and check for parts that were damaged from shipping, missing
parts, or concealed damage. If any discrepancies are discovered, it should be noted with the carrier
prior to accepting the shipment, if possible. File a claim with the carrier if necessary and
immediately notify your Toshiba representative.
• DO NOT install or energize equipment that has been damaged. Damaged equipment may fail
during operation resulting in further equipment damage or personal injury.
• Check to see that the rated capacity and the model number specified on the nameplate conform
to the order specifications.
• Modification of this equipment is dangerous and must not be performed except by factory trained
representatives. When modifications are required contact your Toshiba representative.
• Inspections may be required before and after moving installed equipment.
• Keep the equipment in an upright position as indicated on the shipping carton.
• Contact your Toshiba representative for assistance if required.
IF08CZ10 April, 2019
- xi -