Frame G4P Module Lifting And Installation Continued - Toshiba T300MV2 Instruction Manual

DRIVE INSTALLATION DRAWINGS (cont'd)

Frame G4P module lifting and installation continued

Power Module Installation
1. Lower lifter tray to ground. Roll Power Module onto tray. Secure with chains.(F)
2. Raise tray above Power Module support pan. Lower tray, inserting pins into
holes in front edge of support pan. (E) Set truck brake.
3. Unlatch chains. Roll Power Module by handles from truck onto enclosure rail
until enclosure and Power Module bus stabs touch.
4. Install (1) bolt 'D' at back of cableway. Unlock, remove truck.
5. Install (5) bolts 'C' through bus stabs ACN, P, C, N & ACL. Torque all power
connections (5/16-18 hdwr) to 10-15 ft-lbs.
6. Connect Control Power Cable from wireway as shown at 'B'.
7. Connect Control Cable from wireway to PCB as shown at 'A'.
8. Close upper Power Module cover. Secure with 2 bolts.
9. Replace outside filter cover.
Lifting
Attachment
IF08CZ10 April, 2019
For lifting the Power Module after it is out of
the Cubicle use Lifting Attachment
GCI6723G054 and a lifting device rated at
1000 lbs. or more.
Secure Lifting Attachment to Power Module
with (4) ½-13 Bolts.
- 78 -
Pin in front
edge of lift
tray
E
Power
Module
support pan
F