Sony SRS-HG10 Help Manual page 56

Help Guide
Wireless Speaker
h.ear go 2 (SRS-HG10)
Connecting to a Wi-Fi network using a PC connected wirelessly
Note that the speaker should be initialized to the factory default for this connection. All BLUETOOTH device registration
(pairing) information is deleted. To use the BLUETOOTH connection after that, delete all pairing information on the PC,
and then set pairing again.
This section describes how to connect a PC and the speaker wirelessly, then how to connect the speaker to a wireless
router, using the PC.
Do the following before starting.
Place the speaker closer to the wireless router.
Locate the SSID (the name of a wireless network) and encryption key (WEP or WPA), which are required to set up a
Wi-Fi network. The encryption key restricts access to devices on a network. It is used to make more secure
communication between the devices connected to wireless routers or access points.
Have the Wi-Fi network name (SSID) and password (encryption key) of the wireless router available for
1
reference.
For details, refer to the operating instructions supplied with your wireless router.
With the speaker turned on, press and hold the + (volume) button on the top and the SET UP button on the
2
rear at the same time for more than 4 seconds to initialize the settings of the speaker.
NETWORK indicator, BLUETOOTH indicator, USB indicator and AUDIO IN indicator light up in white, then
initialization starts. Initialization takes about 60 to 80 seconds.
initialization is complete. Initializing the settings will delete all BLUETOOTH pairing information and network
settings.
Connect the speaker to the PC.
3
Windows 7/Windows 8.1:
For Windows 8.1, click or tap the desktop on the Start screen.
Select or
Select [SRS-HG10] from the network list.
Windows 10:
Select or
icon on the bottom right of the screen.
icon on the bottom right of the screen.
(power) indicator lights up in green when
56