Tuning To An Fm Station; Changing The Scan Setting - Bush BD-1728 Instruction Manual

Using your Internet DAB Radio
Let's get started
• If you were listening to a FM station when you switched the radio off, then this station
will automatically be selected when you switch the radio back on.

Tuning to an FM station

Use the rotary Tune/Select control to scroll through the FM frequency band. Alternatively,
you can:
• Press and release the Scan button to scan up the frequency band.
• Press and hold the Scan button to scan down the frequency band.
Note: If reception is still poor try adjusting the aerial or moving the radio to another
location.

Changing the Scan setting

In FM mode:
1. Long press the Menu/Info button. Scan setting is highlighted. Short press the rotary
Tune/Select control to select.
2. Strong stations only? YES NO will be displayed and the NO option will be highlighted.
In you select YES:
If you select NO:
3. Use the rotary Tune/Select control to choose from the two options available and press
to select.
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Your radio will scan for Strong stations only. The scan will
only stop when a strong signal strength is received which
should also result in a better audio quality. It is possible that the
station you are scanning for may be missed using this option.
Your radio will scan for All stations. The scan will stop for
every station it receives, even if the signal strength is poor.
Using your Internet DAB Radio
39