Table of Contents
Advertisement
Using your Mono DAB/FM Radio
Let's get started
•
DRC high - maximum compression.
1. Long press the Menu button to enter the menu options.
2. Use the Prev or Next button to scroll to <DRC>. Short press the Volume control to
Select.
Note: The current DRC setting will have an '*' in the display.
3. Use the Prev or Next button to scroll through the options and short press the Volume
control to Select.
FM Radio mode
•
If you are not already in FM mode, short press the Mode button to go to FM mode
(check the display).
•
If you were listening to an FM station when you switched the Radio off then this
station will be automatically selected when you switch the Radio back on.
Telescopic aerial
Please make sure that the aerial is fully extended before you attempt to tune to a FM
station (a vertical position is recommended). This will ensure that the maximum signal
strength is available when the radio begins to scan. Extending the aerial also ensures the
best possible sound quality.
Tuning to an FM station
•
Long press the Next button to scan up the frequency band.
•
Long press the Prev button to scan down the frequency band.
•
Short press the Prev or Next button to fine tune each frequency in 0.05MHz steps.
Note: If reception is still poor try adjusting the aerial or moving the radio to another
location.
26
Using your Mono DAB/FM Radio
Using your Mono DAB/FM Radio
Let's get started
Changing the Scan setting
In FM mode:
1. Long press the Menu button, <Scan setting> will be displayed. Short press the Volume
control.
The current Scan setting will have an '*' in the display.
There are two different options to choose from:
Strong stations: The scan will only stop when a strong signal strength is received which
should also result in a better audio quality. It is possible that the station
you are scanning for may be missed using this option.
All stations:
The scan will stop for every station it receives, even if the signal strength
is poor.
2. Use the Prev or Next button to choose from the two options available and short press
the Volume control to select.
Storing an FM station preset
Your radio can store up to 10 FM stations in its preset memories for instant access to your
favourite stations.
Note: When you store FM radio station presets, these do not overwrite your DAB
station presets.
1. Tune the Radio to the FM radio station that you wish to preset.
2. Long press the Preset button for approximately 2 seconds until Preset Store
<1:(Empty)> is displayed.
3. Use the Prev or Next button to move to the preset location that you would like to store
the radio station to (1-10).
4. Short press the Volume control to Select, the display will confirm Preset X stored,
where 'X' is the number of the preset (1-10).
section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
27
Using your Mono DAB/FM Radio
Advertisement
Table of Contents
