Fm Radio Mode; Tuning To An Fm Station; Changing The Scan Setting; Audio Mode - Bush DAB30 Instruction Manual

Using your DAB/FM Radio with Bluetooth
Let's get started
There are 3 levels of compression:
• DRC Off: no compression. This is the default setting.
• DRC Low: medium compression.
• DRC High: maximum compression.
1. Press and hold the Menu/Info button until the display changes to 'DAB <Full scan>' .
2. Use the Tune/Select rotary control to scroll to 'DRC' and press to select. The current
DRC setting will have an '*' in the top right of the display.
3. Use the Tune/Select rotary control to scroll through the 3 compression level options
available and press the rotary control to select. Press and release the Menu/Info
button to return to the station display.

FM Radio mode

If you are not already in FM mode, briefly press and release the Mode button to go to FM
mode (check the display). If you were listening to an FM station when you switched the
Radio off then this station will be automatically selected when you switch the Radio back
on.
Telescopic aerial
Please make sure that the aerial is fully extended before you attempt to tune to an FM
station. This will ensure that the maximum signal strength is available when the radio
begins to scan. Extending the aerial also ensures the best possible sound quality.

Tuning to an FM station

Press and release the Scan button on the front of your radio to scan up the frequency
band. Use the left hand rotary control to fine tune each frequency in 0.05MHz steps.
Note: If reception is still poor adjust the position of the aerial or try moving the radio to
another location.
26
Using your DAB/FM Radio with Bluetooth
Using your DAB/FM Radio with Bluetooth
Let's get started

Changing the Scan setting

In FM mode:
1. Press and hold the Menu/Info button until 'FM Scan setting' is displayed. Press the
Tune/Select rotary control to select. The current Scan setting will have an '*' in the top
right of the display.
There are two different options to choose from:
• Strong stations
The scan will only stop when a strong signal strength is received which should also
result in a better audio quality. It is possible that the station you are scanning for may
be missed using this option.
• All stations
The scan will stop for every station it receives, even if the signal strength is poor.
2. Use the Tune/Select rotary control to choose from the two options available and press
to select. Press and release the Menu/Info button to return to the station display.

Audio mode

The radio will automatically switch between Stereo and Mono, depending on the quality
of the signal being received but you can override this function and manually switch
between 'Stereo' and 'Mono' .
Note: You may wish to select 'Stereo' if you are listening to your radio using
headphones.
1. Press and hold the Menu/Info button on the front of the radio until 'FM <Scan setting>'
is displayed.
2. Use the Tune/Select rotary control to scroll to <Audio setting>. Press the Tune/Select
rotary control to select.
There are now two different options of 'Forced mono' and 'Stereo allowed' and the
current setting will have an '*' next to it.
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Using your DAB/FM Radio with Bluetooth
27