Recording Images In Memory; Image Memory Setting Menu; Free Space; Common Tab - Setting The Image Memory Function - Sony IPELA SNC-P1 User Manual

Recording Images in
Memory

— Image memory setting Menu

When you click Image memory on the Advanced mode
menu, the Image memory setting menu appears.
By using the image memory function, you can record the
image and audio file, which has been shot being linked
with the external sensor input or with the built-in motion
detection function, to the built-in memory (about 8 MB)
of the camera. The image file can also be recorded
periodically.
The recorded image and audio files can be found or
downloaded to the computer using the FTP server
function. (See "Downloading Images from the Camera
— FTP server setting Menu" on page 52.)
Image memory setting menu is composed of three tabs
Common, Alarm recording and Periodical recording.
Notes
• The image and audio files recorded in the built-in
memory will be erased when the power of the camera
is turned off.
• The frame rate and operability on the main viewer
may decrease during image storage in the built-in
memory.
• When the Overwrite is set to On, a warning mail is not
sent to the Administrator.
Common Tab — Setting the Image
memory Function
Image memory
Set whether you use the Image memory function or not.
When you select On, the Common setting options are
displayed in the below. If you do not use it, select Off
and click OK.

Free space

Shows the current free space of the builtin memory.
Overwrite
Select to overwrite the file or not when there is
insufficient memory space to record the image.
Select On to allow overwriting. The oldest file or folder
is overwritten first.
Select Off to prohibit overwriting. In this case, a new
file cannot be stored.
Capacity warning
Select On to send a warning mail to the Administrator
when the built-in memory space is low or the memory is
full. Select Off if you do not want to send a warning
mail.
Note
When the Overwrite is set to On, a warning mail is not
sent to the Administrator.
SMTP server name
Type the name of the SMTP server to use for sending an
e-Mail, up to 64 characters.
Otherwise type the IP address of SMTP mail server.
Authentication
Select the authentication required if you send a mail.
None: Select if no authentication is required when an e-
mail is sent.
SMTP authentication: Select if authentication is
required when an e-Mail is sent.
POP before SMTP: Select if POP before SMTP
authentication is required when an e-Mail is sent.
POP server name
This is necessary when POP before SMTP is selected
in Authentication.
Type POP (receiving mail) server name up to 64
characters. Otherwise type the IP address of POP server.
This setting is necessary when SMTP server that sends a
mail authenticates using the account of POP user.
User name, password
Type the user name and the password of the user who
has the mail account. This setting is necessary when
SMTP server that sends a mail authenticates.
Administrator e-Mail address
Type the e-Mail address of the recipient of the warning
mail (e-Mail address of the camera Administrator), up to
64 characters.
Recording Images in Memory — Image memory setting Menu
49